- setFlowControlMode
Sets the flow control mode.
- close
- enableReceiveTimeout
- getInputStream
Returns an input stream. This is the only way to receive data from the
communications port. If the p
- getOutputStream
- setSerialPortParams
Sets the serial port parameters. Default: 9600 baud, 8 data bits, 1 stop bit, no
parity.
- addEventListener
Registers a SerialPortEventListener object to listen forSerialEvents.
- enableReceiveThreshold
- getBaudRate
Returns the currently configured baud rate.
- notifyOnDataAvailable
Expresses interest in receiving notification when input data is available.
- setDTR
Sets or clears the DTR (Data Terminal Ready) signal, if supported by the
underlying implementation.
- setRTS
Sets or clears the RTS (Request To Send) bit in the UART, if supported by the
underlying implementat